Flow controller
Flow controller
Precision made in Germany
The FlexoFlow® is the intelligent flow rate controller, made by AS. The FlexoFlow® is used wherever precise distribution of liquid media is required.
Depending on the version, it can adapt entirely automatically to suit different quantities of oil or water.
Carefree allocation of oil and water
The intelligence that makes monitoring and adjusting liquid media so easy is in the FlexoFlow®. The FlexoFlow® is the appliance of choice in systems with many lubrication points and the requirement for exact lubricant or coolant distribution in particular. It replaces the simple monitoring devices and moves your system into the 21st century from a flow control perspective.
FlexoFlow® regulates
Once you have told the FlexoFlow® what quantity to adjust, the rest is child’s play. Regardless of pressure, temperature and viscosity, the FlexoFlow® now supplies your gearboxes and bearings with oil fully automatically. Bearing overflows are now a thing of the past. Overheating or falling below the dew point of motors are also a thing of the past. Because the FlexoFlow® can also supply cooling water according to the engine temperature. So you can sit back – your FlexoFlow® does the work.
Allocation of oil or water
Liquid media such as oil or water can be monitored and adjusted without problems using the FlexoFlow®. For example, lubrication points are supplied with lubrication or cooling oils, or motors are supplied with the corresponding cooling water.
Full control
“Communication” with the FlexoFlow® is either enabled via the system’s own touch panel or via a Profibus interface. All parameters (e.g. flow rate, alarm and switch-off times, etc.) can therefore be programmed easily. Alarm messages from the FlexoFlow® can also be read out at lightning speed and clearly in this way. You are therefore in full control over all lubrication and coling points.
The advantages at a glance
- simultaneous feedback control of all lubrication points in the system
- no problem to add and expand existing lubrication systems even possible to convert just one assembly group at a time
- pump system pressure can be reduced
- power saving
- protection of all components (pump, filter)
- minimal need for pipework.
