Die Cutting Presses
Belts for Ttarp die cutting presses are available in plastic, extra-hard paper, and poly-coated paper.
Features:
The cutting belt carries product into and out of the press, making notching unnecessary. Stretching and distortion of materials are eliminated. Cut pieces are easy to pick.
Small sheets or pieces can be carried by the belt and positioned accurately under the die.
The die cuts into the belt, not against the steel platen. This prevents damage to the knife edge. Die life is increased up to ten times or more.
Since the cutting rule stays sharper, longer, better quality cuts are produced with less tonnage required.
The clean cut produced by the belt allows feed-thru punches to be used within the die for automatic slug removal by an air clean-out process.
Thru-cutting, kiss cutting and slug removal can all be done with the same die.
Adjustable four-corner stop blocks control the depth of the cut, prolonging belt life.
A make-ready sheet under the belt makes it easy to shim small areas or spots of the die to ensure a 100% clean cut.
Make-ready sheets are stored with the die to save time setting up for the next run. Many dies will not require any set-up because of the cutting belt.
Belts can be replaced easily in five minutes or less.
Belts are low in cost and available in plastic, extra-hard paper, and poly-coated paper.
